★ 4.9 on Google · 200+ reviews

Mold remediation · Bellevue, WA

Attic and crawl space mold removal in Bellevue

Black staining on roof sheathing, fuzzy growth on joists, a musty smell that won't quit. We find the moisture source in your Bellevue home, remove the mold and fix the cause.

  • Bath and kitchen fan ducts that dump air into the attic
  • Staining on north-facing roof sheathing
  • Air leaks at can lights, hatches and wall tops
★★★★★Google reviews4.9 Kirkland · 5.0 Renton
BBB rating A+View profile
Puget Sound Energy Recommended Energy Professional
Home in Bellevue, WashingtonMold remediation for Bellevue homes
  • Free inspectionWith photos of everything we find
  • Licensed, bonded, insuredWashington # ATTICSI795QZ
  • Family-run and localKirkland and Renton offices
  • 4.9 to 5.0 on GoogleKirkland 4.9 · Renton 5.0

Bellevue homes

Mold remediation built around Bellevue houses

A lot of the attic mold we see in Bellevue starts with a bathroom fan. In older homes the fan duct often ends in the attic, or a flexible duct has slipped off its roof vent. Every shower pushes warm, wet air into a cold attic, and it condenses on the underside of the roof deck. North-facing slopes shaded by tall Douglas firs dry out slowly, so staining shows up there first. Buried soffit vents and thin insulation make it worse by letting heat and moisture from the house leak upward all winter, with nowhere for it to go once it's in the attic.

Removing mold without fixing the moisture just schedules the next round. We start by photographing the affected areas and tracing the cause: fan ducts, kitchen vents, air leaks around light fixtures and attic hatches, blocked ventilation, or a roof leak. We remove contaminated insulation, clean and treat the affected wood, and seal the air leaks. Then we reroute fan ducts to vent outside and restore airflow at the soffits. In crawl spaces, we pair cleanup with a new vapor barrier so the ground stops feeding the problem. You get photos of the finished work and a plain explanation of what went wrong.

  • Bath and kitchen fan ducts that dump air into the attic
  • Staining on north-facing roof sheathing
  • Air leaks at can lights, hatches and wall tops
  • Soffit vents buried under old insulation
Mold treatment in an attic
FIG. 01Mold treatment in an attic

Local conditions

What Bellevue throws at attics and crawl spaces

The houses

Most of Bellevue's single-family housing went up between the 1950s and the 1980s. Lake Hills, Crossroads and Eastgate are full of 1950s and 1960s ramblers and split-levels on vented crawl spaces, with low-pitch roofs and shallow attics. Newport Hills and Somerset added 1960s and 1970s split-levels and daylight basements stepped into sloped lots. Bridle Trails has larger custom homes on wooded acre lots. West Bellevue and Woodridge mix originals with big new rebuilds. Older attics often still hold the first layer of fiberglass batts, now thin and compressed, topped with whatever a later owner blew in.

The weather

Bellevue sits between Lake Washington and Lake Sammamish, and humidity stays high through the wet season from October to May. Mercer Slough and Kelsey Creek run through low ground where crawl spaces stay damp. Hillside neighborhoods like Somerset and Newport Hills take more wind in winter storms. Mature Douglas firs and cedars shade many roofs, holding moss and dropping needles that clog gutters and soffit screens.

The wildlife

Bellevue's greenbelts, creek corridors and parks give rodents cover close to houses. Roof rats run fence tops, overhead lines and fir branches to reach roofs, then slip in at roof returns and vent gaps. Norway rats burrow along Kelsey Creek and Mercer Slough and under decks and sheds. Mice move indoors each fall. Raccoons and squirrels test loose vent screens and soffits.

Typical results

What mold remediation looks like

After: sheathing cleaned and the bath fan vented outsideBefore: mold on attic sheathing from a loose bath fan ductBeforeAfter
Before / after. After: sheathing cleaned and the bath fan vented outside · Kirkland, WA

FAQ

Mold remediation in Bellevue: FAQ

Still unsure? Call (800) 674-4933 and talk it through with us.

Is attic mold dangerous to my family?

Mold in the attic is a sign that moisture is damaging the roof deck and insulation, and it can add to musty odors indoors. Don't scrape or sweep it yourself, especially if anyone in the house has asthma or allergies. We contain the work area and wear protective gear during removal.

Will mold come back after remediation?

Not if the moisture source is fixed. That's why we trace the cause before we start. If a bath fan is venting into the attic or the crawl space has no working vapor barrier, cleaning alone won't last. We correct the venting, air sealing or ground cover as part of the job and photograph the results.

Free mold remediation inspection in Bellevue.

Book a free inspection. We'll photograph your attic and crawl space and walk you through what we find, before you decide anything.

CallFree estimate

Request received

Thank you. We've got it.

We'll call you to book your free inspection.

  1. 01We call to set a time that works for you.
  2. 02We inspect and photograph your attic and crawl space.
  3. 03You get a clear written estimate. No obligation.

Urgent? Call (800) 674-4933